Skip to main content
CareerEd LibreTexts

9.4: Decoder

  • Page ID
    955
  • [ "article:topic", "authorname:tkuphaldt", "license:gnu" ]

    A decoder is a circuit that changes a code into a set of signals. It is called a decoder because it does the reverse of encoding, but we will begin our study of encoders and decoders with decoders because they are simpler to design.

    Types of Decoders
    Line Decoder

    A common type of decoder is the line decoder which takes an n-digit binary number and decodes it into 2ndata lines. The simplest is the 1-to-2 line decoder. The truth table is

    14165.webp

    A is the address and D is the dataline. D0 is NOT A and D1 is A. The circuit looks like

    04461.webp

    04480.webp

    2-to-4 Line Coder

    Only slightly more complex is the 2-to-4 line decoder. The truth table is

    14166.webp

    Developed into a circuit it looks like

    04462.webp

    04481.webp

    Larger Line Decoders

    Larger line decoders can be designed in a similar fashion, but just like with the binary adder there is a way to make larger decoders by combining smaller decoders. An alternate circuit for the 2-to-4 line decoder is

    04463.webp

    Replacing the 1-to-2 Decoders with their circuits will show that both circuits are equivalent. In a similar fashion a 3-to-8 line decoder can be made from a 1-to-2 line decoder and a 2-to-4 line decoder, and a 4-to-16 line decoder can be made from two 2-to-4 line decoders.

    You might also consider making a 2-to-4 decoder ladder from 1-to-2 decoder ladders. If you do it might look something like this:

    04482.webp

    For some logic it may be required to build up logic like this. For an eight-bit adder we only know how to sum eight bits by summing one bit at a time. Usually it is easier to design ladder logic from boolean equations or truth tables rather than design logic gates and then “translate” that into ladder logic.

    A typical application of a line decoder circuit is to select among multiple devices. A circuit needing to select among sixteen devices could have sixteen control lines to select which device should “listen”. With a decoder only four control lines are needed.